5/2/2023 0 Comments Macvim yank across windowsPress P to paste the line above the cursor.Press p to paste the line below the cursor.The methods for copying or moving small blocks of text in vi involves the use of a combination of the yank, delete, and put commands. Copying and Moving Text - Yank, Delete, and Put To delete part of a word, position the cursor on the word to the right of the part to be saved. The word and the space it occupied are removed. Press X to delete one character before (to the left of) the cursor.Press x to delete one character where the cursor is presently.vi stays in command mode, so any subsequent text insertions must be preceded by additional commands to enter entry mode. These vi commands delete the character, word, or line you indicate. Press U to undo all changes you’ve made to a line.Press u to undo a change which you did previously.vi’s undo commands enable you to back up one operation and continue on from there. When you edit text and make changes to a vi file, you might occasionally wish that you had not changed something. Press r to replace the character highlighted by the cursor with another character, followed by just one replacement character.Īfter the substitution, vi automatically returns to command mode (you do not need to press Esc).Press s to substitute one or more characters for the character under the cursor, followed by the new text.The line disappears, leaving a blank line for your new text. Type cw, type the correction, and press Esc. To change some part of a word, place the cursor on the word, to the right of the portion to be saved. Press cw to replace a word, followed by the new word.Type O to open a line above the current cursor position.Ĭhanging text involves the substitution of one section of text for another.Type o to open a line below the current cursor position.Use these commands to open new lines, either above or below the current cursor position. Press I to insert text at the beginning of a line.Press i to insert text to the left of the cursor.Type A to add text to the end of a line.Type a (append) to insert text to the right of the cursor.Remember to press Esc to make sure you are in command mode. To use any of these commands, you must first be in command mode. Each of these commands places vi in entry mode. Vi provides many commands for inserting text. Press L (“low”) to move the cursor to the bottom of the screen.Press M (“middle”) to move the cursor to the middle of the screen.Press H (“high”) to move the cursor to the top of the screen.Press $ to move the cursor to the end of the current line.
0 Comments
Leave a Reply. |